پیوندهای مفید
آمار
| تعداد نشریات | 21 |
| تعداد شماره‌ها | 610 |
| تعداد مقالات | 9,026 |
| تعداد مشاهده مقاله | 67,082,725 |
| تعداد دریافت فایل اصل مقاله | 7,656,155 |
Determination of stationary region boundary in multiple reference frames method in a mixing system agitated by Helical Ribbon Impeller using CFD | ||
| Journal of Heat and Mass Transfer Research | ||
| مقاله 4، دوره 2، شماره 1 - شماره پیاپی 3، مرداد 2015، صفحه 31-37 اصل مقاله (841.69 K) | ||
| نوع مقاله: Full Length Research Article | ||
| شناسه دیجیتال (DOI): 10.22075/jhmtr.2015.337 | ||
| نویسندگان | ||
| Maryam Sanaie-Moghadam؛ Mansour Jahangiri* ؛ Faramarz Hormozi | ||
| School of Chemical& Petroleum and Gas Engineering, Semnan University, Semnan, Iran. | ||
| تاریخ دریافت: 07 اردیبهشت 1393، تاریخ بازنگری: 07 تیر 1393، تاریخ پذیرش: 31 تیر 1393 | ||
| چکیده | ||
| The multiple reference frames (MRF) method is the most suitable method to simulate impeller rotation in mixing systems. Precise determination of stationary and moving zones in MRF method leads to accurate results in mixing performance. In this research, the entire volume of mixing system was divided into two zones. The kinetic energy values were used to distinguish the zones with different velocities. The low-velocity zones, close to zero, were considered as the stationary zone and higher velocities were considered as the moving zone. The standard geometrical parameters were used for mixing system. The axial velocity and axial flow number were compared with literatures for validation. The values for dimensionless diameter of stationary zone at different Reynolds numbers were achieved for Newtonian and non-Newtonian fluids that are in agreement with values applied in literatures. The results show that the dimensionless diameter of stationary zone decreases as Reynolds number increases. | ||
| کلیدواژه‌ها | ||
| CFD؛ MRF؛ Helical Ribbon؛ Impeller؛ Mixing؛ Non-Newtonian fluid | ||
| مراجع | ||
|
[1]. P.J. Carreau, I. Patterson, C.Y. Yap, "Mixing of viscoelastic fluids with helical-ribbon agitators - I. Mixing time and flow patterns," Can. J. Chem. Eng. 54 (1976) pp. 135-142.
[2]. S.M. Shekhar, S. Jayanti, "Mixing of Pseudoplastic Fluids Using Helical Ribbon Impellers," AIChE J. 49 (2003) pp. 2768-2772.
[3]. M. Jahangiri, "Velocity distribution of helical ribbon impeller in mixing of polymeric liquids in the transition region," Iranian Polymer J. 16 (2007) pp. 731-739.
[4]. M. Jahangiri, "Shear Rates in Mixing of Viscoelastic Fluids by Helical Ribbon Impeller," Iranian Polymer J. 17 (2008) pp. 831-341.
[5]. K. Takahashi, Y. Takahata, T. Yokota, H. Konno, "Mixing of two miscible highly viscous Newtonian liquid in a helical ribbon agitator," J. Chem. Eng. Japan. 18 (1985) pp. 159-162.
[6]. P. J. Carreau, R.P. Chhabra, J. Cheng, "Effect of rheological properties on power consumption with helical ribbon agitators," AIChE J. 39 (1993) pp. 1421-1430.
[7]. G. Delaplace, J.C. Leuliet, V. Relandeau, "Circulation and mixing times for helical ribbon impellers. Review and experiments," Experiments in Fluids. 28 (2000) pp. 170–182.
[8]. I. Ihejirika, F. Ein-Mozaffari, "Using CFD and Ultrasonic Velocimetry to Study the Mixing of Pseudoplastic Fluids with a Helical Ribbon Impeller," Chem. Eng. Technol. 30 (2007) pp. 606-614.
[9]. W.I. Patterson, P.J. Carreau, C.Y. Yap, "Mixing with helical ribbon agitators, Part II. Newtonian fluids," AIChE J. 25 (1979) pp. 508-516.
[10]. K.V. Vyakaranam, J.L. Kokini, "Advances in 3D Numerical Simulation of Viscous and Viscoelastic Mixing Flows," in: J.M. Aguilera, Simpson R, Welti-Chanes J, Bermudez Aguirre D, Baebosa-Canovas G (Eds.) Food Engineering interfaces, Springer Science, Business Media, (2011), pp. 19-44.
[11]. P.M. Armenante, C. Luo, C.C. Chou, I. Fort, J. Medek, "Velocity profiles in a closed, unbaffled vessel: comparison between experimental LDV data and numerical CFD prediction," Chem. Eng. Sci. 52 (1997) pp. 3483-3492.
[12]. D. Anne-Archard, M. Marouche, H.C. Boisson, "Hydrodynamics and Metzner-Otto correlation in stirred vessels for yield stress fluids," Chem. Eng. J. 125 (2006) pp. 15-24.
[13]. J. Aubin,I. Naude, C. Xuereb, J. Bertrand, "Blending of Newtonian and Shear‐Thinning Fluids in a Tank Stirred with a Helical Screw Agitator," Cherd Trans. IChemE. 78 (2000) pp. 1105‐1114.
[14]. J. Aubin, I. Naude, C. Xuereb, "Design of Multiple Impeller Stirred Tanks for the Mixing of Highly Viscous Fluids Using CFD," Chem. Eng. Sci. 61 (2006) pp. 2913-2920.
[15]. B. Letellier, C. Xuereb, P. Swaels, P. Hobbes, J. Bertrand, "Scale-up in laminar and transient regimes of a multi-stage stirrer, a CFD approach,"Chem. Eng. Sci. 57 (2002) pp. 4617-4632.
[16]. R. Sanjuan-Galindo, M. Heniche, G. Ascanio, P.A. Tanguy, "CFD investigation of new helical ribbon mixers bottom shapes to improve pumping," Asia-Pac. J. Chem. Eng. 6 (2011) pp.181–193.
[17]. H. Ameur, M. Bouzit, M. Helmaoui, "Numerical study of fluid and power consumption in a stirred vessel with a Scsbs 6SRGT impeller," Chem. Process Eng. 32 (2011) pp.351-366.
[18]. H. Ameur, M. Bouzit, "Agitation of Yield Stress Fluids by Two-Blade Impellers," Canadian J. on Chem. Eng. Technol. 3 (2012) pp. 93-99.
[19]. H. Ameur, M. Bouzit, M. Helmaoui, "Hydrodynamic study involving a maxblend impeller with yield stress fluids," J. Mech. Sci. Technol. 26 (2012) pp. 1523-1530.
[20]. S. Youcefi, M. Bouzit, H. Ameur, Y. Kamla, A. Youcefi, "Effect of some design parameters on the flow fields and power consumption in a vessel stirred by a Rushton Turbine," Chem. process Eng. 34 (2013) pp. 293-307.
[21]. J.Y. Luo, I. Issar, A.D. Gosman, "Prediction of impeller induced flows in mixing vessels using multiple frames of reference," Proceeding Institution Chem. Eng. 136 (1993) 549-556.
[22]. M. Zhang, L. Zhang, B. Jiang, Y. Yin, X. Li, "Calculation of Metzner Constant for Double Helical Ribbon Impeller by Computational Fluid Dynamic Method," Chinese J. Chem. Eng. 16 (2008) pp. 686-692.
[23]. M. Rahimi, A. Kakekhani, A. AbdulazizAlsairafi, "Experimental and computational fluid dynamic (CFD) studies on mixing characteristics of a modified helical ribbon impeller," Korean J. Chem. Eng. 27 (2010) pp.1150-1158.
[24]. Y. Tsui, Y. Hu, Eng. "Flow characteristics in mixers agitated by helical ribbon blade impeller," Application of Computational Fluid Mechanics. 5 (2011) pp.416-429.
[25]. L.W. Adams, "Experimental and computational study of non-Turbulent flow regimes and cavern formation of non-Newtonian fluids in a stirred tank,' PhD thesis, Birmingham, 2009, B15 2TT.
[26]. V.V. Chavan, R.A. Mashelkar, "Mixing of viscous Newtonian and non-Newtonian fluids," in: A.S. Mujumdar (Ed.) Advances in Transport Processes, Wiley Eastern/Wiley Halsted, 1980, pp. 210-252. | ||
|
آمار تعداد مشاهده مقاله: 3,975 تعداد دریافت فایل اصل مقاله: 1,775 |
||