Statistical Analysis of Nanofluid Heat Transfer in a Heat Exchanger using Taguchi Method

[1] Choi SUS, editor Enhancing thermal conductivity of fluids with nanoparticles. Proceedings of the 1995 ASME International Mechanical Engineering Congress and Exposition; 1995; New York, USA.
[2] Abbasian Arani AA, Amani J. Experimental study on the effect of TiO2–water nanofluid on heat transfer and pressure drop. Exp Therm Fluid Sci. 2012;42(0):107-15.
[3] Zamzamian A, Oskouie SN, Doosthoseini A, Joneidi A, Pazouki M. Experimental investigation of forced convective heat transfer coefficient in nanofluids of Al2O3/EG and CuO/EG in a double pipe and plate heat exchangers under turbulent flow. Exp Therm Fluid Sci. 2011;35(3):495-502.
[4] Ali HM. In tube convection heat transfer enhancement: SiO2 aqua based nanofluids. J Mol Liq. 2020;308:113031.
[5] Farajollahi B, Etemad SG, Hojjat M. Heat transfer of nanofluids in a shell and tube heat exchanger. Int J Heat Mass Transfer. 2010;53(1–3):12-7.
[6] Karouei SHH, Ajarostaghi SSM, Gorji-Bandpy M, Fard SRH. Laminar heat transfer and fluid flow of two various hybrid nanofluids in a helical double-pipe heat exchanger equipped with an innovative curved conical turbulator. J Therm Anal Calorim. 2020:1-12.
[7] Shirzad M, Ajarostaghi SSM, Delavar MA, Sedighi K. Improve the thermal performance of the pillow plate heat exchanger by using nanofluid: numerical simulation. Adv Powder Technol. 2019;30(7):1356-65.
[8] Hamedani FA, Ajarostaghi SSM, Hosseini SA. Numerical evaluation of the effect of geometrical and operational parameters on thermal performance of nanofluid flow in convergent–divergent tube. J Therm Anal Calorim. 2019:1-23.
[9] Zaboli M, Ajarostaghi SSM, Noorbakhsh M, Delavar MA. Effects of geometrical and operational parameters on heat transfer and fluid flow of three various water based nanofluids in a shell and coil tube heat exchanger. SN Applied Sciences. 2019;1(11):1387.
[10] Ajarostaghi SSM, Zaboli M, Nourbakhsh M. Numerical evaluation of turbulence heat transfer and fluid flow of hybrid nanofluids in a pipe with innovative vortex generator. J Therm Anal Calorim. 2020:1-15.
[11] Zaboli M, Nourbakhsh M, Ajarostaghi SSM. Numerical evaluation of the heat transfer and fluid flow in a corrugated coil tube with lobe-shaped cross-section and two types of spiral twisted tape as swirl generator. J Therm Anal Calorim. 2020:1-17.
[12] Tajik Jamal-Abad M, Dehghan M, Saedodin S, Valipour MS, Zamzamian A. An experimental investigation of rheological characteristics of non-Newtonian nanofluids. Journal of Heat and Mass Transfer Research. 2014;1(1):17-23.
[13] Bozorgan N, Shafahi M. Analysis of gasketed-plate heat exchanger performance using nanofluid. Journal of Heat and Mass Transfer Research. 2017;4(1):65-72.
[14] Aminian MR, Miroliaei AR, Mirzaei Ziapour B. Numerical study of flow and heat transfer characteristics of CuO/H2O nanofluid within a mini tube. Journal of Heat and Mass Transfer Research. 2019;6(1):11-20.
[15] YadollhiFarsani R, Raisi A, Ahmadi Nadooshan A. Experimental Investigation of the Alumina/Paraffin Thermal Conductivity Nanofluids with a New Correlated Equation on Effective Thermal Conductivity. Journal of Heat and Mass Transfer Research.6(2):85-93.
[16] Parvar M, Saedodin S, Rostamian SH. Experimental study on the thermal conductivity and viscosity of transformer oil-based nanofluid containing ZnO nanoparticles. Journal of Heat and Mass Transfer Research. 2020.
[17] Vermahmoudi Y, Peyghambarzadeh S, Naraki M, Hashemabadi S. Statistical analysis of nanofluid heat transfer in a heat exchange system. J Thermophys Heat Transfer. 2013.
38 B. Raei/ JHMTR 8(2021) 29- 38
[18] Do Kim K, Kim SH, Kim HT. Applying the Taguchi method to the optimization for the synthesis of TiO2 nanoparticles by hydrolysis of TEOT in micelles. Colloids Surf Physicochem Eng Aspects. 2005;254(1-3):99-105.
[19] Chou C-S, Wu C-Y, Yeh C-H, Yang R-Y, Chen J-H. The optimum conditions for solid-state-prepared (Y3− xCex) Al5O12 phosphor using the Taguchi method. Adv Powder Technol. 2012;23(1):97-103.
[20] Mohammadi T, Safavi MA. Application of Taguchi method in optimization of desalination by vacuum membrane distillation. Desalination. 2009;249(1):83-9.
[21] Yusoff N, Ramasamy M, Yusup S. Taguchi's parametric design approach for the selection of optimization variables in a refrigerated gas plant. Chem Eng Res Des. 2011;89(6):665-75.
[22] Chiang K-T. Optimization of the design parameters of Parallel-Plain Fin heat sink module cooling phenomenon based on the Taguchi method. Int Commun Heat Mass. 2005;32(9):1193-201.
[23] Madaeni S, Koocheki S. Application of taguchi method in the optimization of wastewater treatment using spiral-wound reverse osmosis element. Chem Eng J. 2006;119(1):37-44.
[24] Chou C-S, Lin S-H, Peng C-C, Lu W-C. The optimum conditions for preparing solid fuel briquette of rice straw by a piston-mold process using the Taguchi method. Fuel Process Technol. 2009;7(90):1041-6.
[25] Raei B, Shahraki F, Jamialahmadi M, Peyghambarzadeh SM. Different methods to calculate heat transfer coefficient in a double-tube heat exchanger: A comparative study. Experimental Heat Transfer. 2018;31(1):32-46.
[26] Raei B, Shahraki F, Jamialahmadi M, Peyghambarzadeh SM. Experimental investigation on the heat transfer performance and pressure drop characteristics of γ-Al2O3/water nanofluid in a double tube counter flow heat exchanger. Transport Phenomena in Nano and Micro Scales. 2016;5(1):64-75.
[27] Raei B, Shahraki F, Peyghambarzadeh SM. Experimental study of the effect of drag reducing agent on heat transfer and pressure drop characteristics. Experimental Heat Transfer. 2018;31(1):68-84.
[28] Raei B, Shahraki F, Jamialahmadi M, Peyghambarzadeh S. Experimental study on the heat transfer and flow properties of γ-Al2O3/water nanofluid in a double-tube heat exchanger. J Therm Anal Calorim. 2017;127(3):2561-75.
[29] Raei B, Peyghambarzadeh SM. Measurement of Local Convective Heat Transfer Coefficient of Alumina-Water Nanofluids in a Double Tube Heat Exchanger. Journal of Chemical and Petroleum engineering. 2019;53(1):25-36.
[30] Moffat RJ. Describing the uncertainties in experimental results. Exp Therm Fluid Sci. 1988;1(1):3-17.
[31] Montgomery DC. Design and analysis of experiments: John wiley & sons; 2017.
[32] Kotcioglu I, Cansiz A, Khalaji MN. Experimental investigation for optimization of design parameters in a rectangular duct with plate-fins heat exchanger by Taguchi method. Appl Therm Eng. 2013;50(1):604-13.
[33] Sivasakthivel T, Murugesan K, Thomas HR. Optimization of operating parameters of ground source heat pump system for space heating and cooling by Taguchi method and utility concept. Applied Energy. 2014;116:76-85.
[34] Lu S-M, Li Y-C, Tang J-C. Optimum design of natural-circulation solar-water-heater by the Taguchi method. Energy. 2003;28(7):741-50.
[35] Duangthongsuk W, Wongwises S. An experimental study on the heat transfer performance and pressure drop of TiO2-water nanofluids flowing under a turbulent flow regime. Int J Heat Mass Transfer. 2010;53(1–3):334-44.
[36] Kim D, Kwon Y, Cho Y, Li C, Cheong S, Hwang Y, et al. Convective heat transfer characteristics of nanofluids under laminar and turbulent flow conditions. Curr Appl Phys. 2009;9(2, Supplement):e119-e23.