Increase Power Grid Stability Using Dual-Excited Synchronous Generator

A. R. Daniels and Y. B. Lee, "Optimal and suboptimal excitation control of dual-excited synchronous generators", Proc. I. E. E., vol. 123, no. 10, pp. 989-992, 2010.

[2]

A. A. Reddy, S. S. Bhat, and R. T. Ugale, "Design and FEM analysis of dual excited synchronous generator." 2017 National Power Electronics Conference (NPEC). IEEE, pp. 302-306, 2017.

[3]

R. B. Robinson, "Transient equivalent circuit of the divided winding rotor synchronous machine", Proc. I.E.E., vol. 117, pp. 552-554, 1970.

 

[4]

H. Yaghobi and H. Kafash Haghparas, " Study on application of two different magnetic materials in rotor of cylindrical synchronous generator to produce reluctance torque", Iranian Journal of Electrical & Electronic Engineering, Vol. 11, No.3, pp. 253-264, 2015.

[5]

R. Ilka and Y. Alinejad-Beromi, “A Novel Space Reduction Technique for Design Optimization of Permanent Magnet Synchronous Motors”, Modeling and Simulation in Electrical and Electronics Engineering, vol. 2, pp. 1-7, 2022.

[6]

A. Ehsani-Seresht, A. Bolourian, and R. RoshanFekr, “Detection of the Misalignment Fault in Non-Electric Rotating Machines Through the Current Signal of a Brushless Direct Current Motor”,  Modeling and Simulation in Electrical and Electronics Engineering, vol.2, pp. 11-17, 2022.

[7]

R. H. Nelson, T. A. Lipo, and P. C. Krause, "Stability analysis of a symmetrical induction machine", IEEE Trans. Power App. Syst., vol. PAS-88, no. 11, pp. 1710-1717, Nov. 1969.

[8]

C. P. Steinmetz, "Power control and stability of electric generating stations", AIEE Trans., vol. XIX, Part II, pp. 1215-1287, July 1920.

[9]

A. Samii, A. Akram, and H. Ardiny, "Comparison of PI and Adaptive Fuzzy Controllers for Position Tracking of Servo System with Variable Loaded BLDC Motor."  in 2022 10th RSI International Conference on Robotics and Mechatronics (ICRoM). IEEE, 2022.

[10]

A. Samii, F. Lotfi, and H. D. Taghirad, “Optimization of Battery Life and State of the Charge in an Electric Motorcycle Braking System,” in 2021 9th RSI International Conference on Robotics and Mechatronics (ICRoM), 2021, pp. 203–209.

[11]

M. Pavella and P. G. Murthy, Transient Stability of Power Systems: Theory and Practice, NY, New York, 1994.

[12]

H. Yaghobi, "Transient stability enhancement of power system with instability tolerant synchronous generator", IET Generation, Transmission & Distribution, vol. 14, no. 21, pp. 4654-65, 2020.

[13]

P. Kundur, J. Paserba, V. Ajjarapu, G. Andersson, A. Bose, C. Canizares, et al., "Definition and classification of power system stability", IEEE Trans. Power Syst., vol. 19, no. 3, pp. 1387-1401,  2004.

[14]

R. G. Harley and B. Adkins, "Stability of synchronous machine with divided winding rotor", Proc. I.E.E., vol. 117, pp. 933-947, 1970.

[15]

M. Eremia and M. Shahidehpour, Handbook of Electrical Power System Dynamics: Modeling Stability and Control, Hoboken, NJ, USA: Wiley, vol. 92, 2013.

[16]

S. Ghafouri, M. A. Hajiahmadi, M. Firouzi, G. B. Gharehpetian, S. Mobayen, and P. Skruch, "Improving Transient Stability of a Synchronous Generator Using UIPC with a Unified Control Scheme," Energies, vol. 15, no. 16, pp. 6072, 2022.

[17]

H. M. Yassin, R. R. Abdel-Wahab, and H. H. Hanafy, "Active and reactive power control for dual excited synchronous generator in wind applications," IEEE Access, vol. 10, pp. 29172-29182, 2022.

[18]

G. Xu, Z. Li, Z. Wang, W. Li, Y. Zhan, H. Zhao, et al., "Power tracking excitation control and its parameter optimization of dual-excited synchronous generator," IEEE Trans. Ind. Appl., vol. 58, no. 6, pp. 7099-7109, 2022.

[19]

G. Xu, Y. Fu, Y. Zhan, Z. Wang, H. Zhao, and Y. Zhang, "Influence of Different Rotor Damping Structures on Dynamic Characteristic of Dual-Excited Synchronous Generator with Excitation Control," IEEE Trans. Ind. Appl., 2023.

[20]

G. Xu, L. Wang, Z. Li, Z. Li, H. Zhao, Y. Zhan, et al., "Improvement of Reactive Power Consumption Ability for Dual-Excited Synchronous Condenser," IEEE Trans. Ind. Appl., 2024.

[21]

G. Wang, L. Fu, Q. Hu, C. Liu, and Y. Ma, "Transient synchronization stability of grid-forming converter during grid fault considering transient switched operation mode," IEEE Trans. Sustain. Energy, 2023.

[22]

P. Subramaniam and 0. P. Malik, "Dynamic stability analysis of DWR synchronous generator with feedback stabilized voltage and angle regulators", Proc. I.E.E. vol. 118, no. 12, pp. 1768-1774,  1971.

[23]

B.N. Sarkar, V.K. Verma, and P. Mukhopadhyay, "Effect of field failure of a D.W.R. generator", Proc. I.E.E. vol. 127, no. 2, pp. 82-89, 1980.

[24]

H. Mangel, G. Barbier, Y. Shakaryan, Y. Vinitzky, and J. M. Kauffmann, "Influence of field windings positions on two-axis excitation generators transient behavior", 1997 IEEE International Electric Machines and Drives Conference Record, pp. TC1/11.1-TC1/11.3, 1997.

[25]

]C. S. Brune, R. Spe´e and A. K. Wallace, "Experimental evaluation of a variable-speed doubly-fed wind-power generation system", IEEE Trans. Ind. Applicant., vol. 30, pp. 648-655, 1994.

[26]

]D. Zhou, R. Spee and G. C. Alexander, "Experimental evaluation of a rotor flux oriented control algorithm for brushless doubly-fed machines", IEEE Trans. Power Electron., vol. 12, pp. 72-78, 1997.

[27]

A. Kemp et al., "Investigation of rotor current distribution in brushless doubly-fed machines", Proc. IEEE Ind. Appl. Soc. Annu. Meeting, pp. 638-643, 1996.

[28]

M. S. Vicatos and J. A. Teqopoulos, "Steady-state analysis of a doubly-fed induction generator under synchronous operation", IEEE Trans. Energy Convers., vol. 4, no. 3, pp. 495-501, 1989.

[29]

O. Honorati, F. Caricchi, F. Crescimbini, and G. Noia, "Stabilization and speed control of a hypersynchronous doubly-fed motor: tests and experimental results", Fifth Int. Conf. on Electrical Machines and Drivers, pp.203-207, 1991.

[30]

O. Honorati, F. Caricchi, F. Crescimbini, and E. Santini, "The high speed, doubly fed synchronous motor: stabilization performances." Conference Record of the 1990 IEEE Industry Applications Society Annual Meeting. IEEE, 1990.

[31]

S. E. Abo-Shady, F. I. Ahmed, A. M. El-Hakim and M. A. Badr, "Analysis of Self-Dual Excited Synchronous Machine(part(I), Development of the General Mathematical Model and Steady-state Performance Experimental Verification ", IEEE Trans.  Energy Convers., vol. 3, no. 2, pp. 305-314, 1988.

[32]

S. E. Abo-Shady, F. I. Ahmed and A. M. El-Hakim, "Analysis of self-dual excited synchronous machine. II. Small perturbation model and dynamic behavior." IEEE Trans. Energy Convers., vol. 3, no. 2, pp. 315-322, 1988.

[33]

A. M. A. Oteafy and J. N. Chiasson, "A standstill parameter identification technique for the divided winding rotor synchronous generator", 2014 IEEE International Conference on Power and Energy (PECon), pp. 99-104, 2014.

[34]

R. R. Abdel-Wahab, H. M. Yassin, and H. H. Hanafy, "Dual Excited Synchronous Generator a Suitable Alternative for Wind Applications", 2020 IEEE 14th International Conference on Compatibility, Power Electronics and Power Engineering (CPE-POWERENG), vol. 1, pp. 352-357. IEEE, 2020.

[35]

S. D'Arco, L. Piegari, and P. Tricoli, "A Novel control of dual-excited synchronous machines for variable speed wind turbines", IEEE Trondheim PowerTech, 2011

[36]

P. C. Krause and J. N. Towle, "Synchronous Machine Damping by Excitation Control with Direct and Quadrature Axis Field Winding", IEEE Transactions, vol. PAS-88, pp. 1266-1274, 1969.

[37]

C. M. Ong, Dynamic Simulation of Electric Machinery, NJ, Englewood Cliffs: Prentice-Hall, 1998.

[38]

J. C. Peqqueña, E. Ruppert and M. T. Mendoza, “On the synchronous generator parameters determination using dynamic simulations based on IEEE standards”, 2010 IEEE International Conference on Industrial Technology, pp. 386-391, 2010.