Mode Shape-Based Damage Localization in Steel Plates Using a Detection Index Based on 2D Wavelet Analysis | ||
| Journal of Rehabilitation in Civil Engineering | ||
| مقاله 3، دوره 11، شماره 4 - شماره پیاپی 32، زمستان 2023، صفحه 44-64 اصل مقاله (1.71 M) | ||
| نوع مقاله: Regular Paper | ||
| شناسه دیجیتال (DOI): 10.22075/jrce.2022.27310.1658 | ||
| نویسندگان | ||
| Mohtasham Khanahmadi1؛ Majid Gholhaki* 2؛ Omid Rezaifar2؛ Adel Younesi3 | ||
| 1M.Sc. of Structural Engineering, Faculty of Civil Engineering, Semnan University, Semnan, Iran | ||
| 2Professor, Faculty of Civil Engineering, Semnan University, Semnan, Iran | ||
| 3Ph.D. of Structural Engineering, Faculty of Civil Engineering, Semnan University, Semnan, Iran | ||
| چکیده | ||
| Structures are subjected to a variety of environmental and loading conditions over time, and minor damage to structural elements may occur. By timely identifying damage and repairing damaged locations, it is possible to prevent the spread and development of damage to other elements and, as a result, the overall destruction of the structure. This article discusses the identification and determination of the location of damage in steel plates based on the use of the primary and secondary shapes of vibration modes and the analytical method of two-dimensional wavelet analysis. Modelling and frequency analysis of the plate were performed in ABAQUS software, and the primary and secondary mode shapes were extracted. To determine the location of the damage, a damage detection index (DDI) was proposed based on the angle between the primary and secondary mode shape vectors and the diagonal detail coefficients obtained from the wavelet analysis of the primary and secondary mode shapes. The results showed that by using this index, damage can be identified by identifying peaks resulting from irregularities and disturbances. Also, the DDI value of the damage was dependent on the severity of damage occurring in a damaged situation, and the height of the disorder peaks increased with increased damage only at that damage position. | ||
| کلیدواژهها | ||
| Damage identification؛ Steel plate؛ Mode shape؛ 2D wavelet analysis؛ Damage detection index | ||
| مراجع | ||
|
| ||
|
آمار تعداد مشاهده مقاله: 1,587 تعداد دریافت فایل اصل مقاله: 708 |
||
| تعداد نشریات | 22 |
| تعداد شمارهها | 718 |
| تعداد مقالات | 10,317 |
| تعداد مشاهده مقاله | 72,313,698 |
| تعداد دریافت فایل اصل مقاله | 64,038,555 |